Hardware Tip of the Week: Drilling into Ceramic Tile and Washing Machine Tune-Up

By / Hardware Tips / Wednesday, 04 February 2015 05:00

Sponsored by:
801 N. Lake Park Blvd.   Carolina Beach, NC  28428 Phone: (910) 458-3049  
Fax: (910) 458-0988


Drilling: Planning to drill holes in ceramic tile to install a towel bar, shelf or paper holder? If so, you need to know how to drill straight and true, so you won't be slip-sliding away.
To do it right you need two things:
1. A special carbide tip drill bit -- the kind used for masonry. Regular drill bits can't penetrate the hard fire-glazed surface.
2. Something to keep the drill bit in place until it begins cutting through, rather than slipping around on the slick surface. The answer? -- a roll of masking tape.
Use two strips to make an X, place it over your mark and drill right through it. At first it'll grind as you cut through the glaze.
Then it will go more easily through the ceramic back and real easily through the softer wall behind it. Ease up toward the end to avoid pushing out the backside of the drywall or backerboard.
The cleaner the hole -- both through and inside -- the better your hollow-wall fasteners will grip and hold.
Washing Machine:
If your washing machine starts acting up filling slowly or maybe not at all here’s what to do before you call a repairman or decide to go shopping for a new one.
Probably over the years it’s filled slower and slower but you didn’t notice. Now that it’s stopped completely that you notice and you’re concerned.
First take a minute to check  things out. Is the water turned on?
Or did someone turn it off? If that’s okay, turn the water off and inspect both hoses running to the machine. Unscrew each one and check the small screen filters in the hose end fittings.
Often they slowly clog up until they will not let any water pass through.
Clean them, replace and reattach the hoses, turn on the water and you may be surprised to find that it now fills and works just fine.
And that’s the tip of the week from Island True Value Tackle and Hardware.


Super User

Super User





Please publish modules in offcanvas position.